Vertical surfaces

After striking shutters, dampen down the concrete thoroughly with fresh water. Allow the surface water to drain off then apply Ecocure S either with standard spray equipment or a lamb’s wool roller (spray applications are preferred for full coverage). Observe that the surface is fully wetted. Where a highly durable abrasion resistant surface is required, i.e., in severe exposure conditions, apply a further coat of Ecocure after 3 days. Where subsequent surfacing systems are to be applied, allow 7 days before overlaying Ecocure S.

Horizontal Surface

Apply Ecocure S with spray equipment or a lamb’s wool roller immediately after final trowel when all bleed water has disappeared. Ensure full surface wetting and in any case apply not less than the coverage specified below. Earliest practical application after the concrete surfaces are ready to receive the curing compound is recommended so as to obtain optimum performance from the system. As for vertical surfaces, apply a second coat to maximize durability and abrasion resistance.

All Surfaces

If the concrete is exposed to direct sunlight with high temperatures (plus 23˚ C), or severe drying winds, protect the surface with a polythene sheet for 2-3 hours. After applying Ecocure S to allow time for crystal formation. The polythene should be in direct contact with the surface to maximize the benefits.