Ecofloor Mortar
Ecofloor Mortar
Cementitious Self-leveling sub-floor screed
100% Trusted by our clients
High Strength Flooring Concrete Repair
Self-leveling and highly fluid
Pump or manual application
Rapid drying
4 hours walk on time at 20º C
Low Odor
Low installed cost
Total value: Php 1,548.88
Today Just:
Php 792.46 / Bag - 25 Kg
Trusted by our Clients
Ecofloor Hard Technical Data
Description
Ecofloor is a one component, versatile and durable, sub-floor cementitious screed which can be applied manually or by pump to achieve rapid, flat and economic substrate prior to the application of the floor finish.
Uses
Ecofloor mortar is a sub-floor cementitious screed for use as an underlayment for other floor finishes such as carpet, vinyl, ceramic tiles & epoxy coating Systems.
Application
Surface preparation
The surface must be clean and free from all traces of loose material, old coatings, curing membranes, release agents, laitance, oil and grease, etc. Surfaces may be damp but free from standing water.
Substrate compression strength should be at least 20 Mpa.
Structurally unsound layers and surface containments must be mechanically removed. Captive shot blasting followed by vacuuming to remove dust is the preferred method for large areas.
Priming
Priming with Ecolatex is essential to ensure good adhesion and reduce air release from the substrate. Apply Ecolatex by brush ensuring complete wetting out of the substrate. The primed substrate should be tacky condition at the time of applying Ecofloor Mortar.
Mixing
Ecofloor mortar should be mixed using drill and suitable paddle or a continuous mixer/pump.
To each 25kg bag of Ecofloor mortar, add 4.5 liters of clean water and mix until a homogenous, self-leveling consistency is achieved.
Always add the powder to the water while mixing slowly to avoid the formation of lumps.
Curing
Ecofloor mortar is self-curing, but as with all cementitious products in hot weather, take adequate measures to protect it from exposure to direct sunlight and hot winds. The application of curing membrane or water is not necessary. Cleaning
Clean all tools and equipment with water immediately after use. Hardened mortar can only be mechanically removed.
Application Proper
Apply the Ecofloor mortar to the substrate using a trowel squeegee, spreading rake or screed bar to give the required finish thickness. The product can also be applied by pump. Thoroughly spike roller in two directions to remove trowel marks and any entrapped air.
Maximum thickness applied in one application is 25 mm. If 2 or more layers are required, bonding agent must be applied between layers.
Performance
Flow Test
Water Content (%)
Setting Time
Bleeding
Comprehensive Strength
British Standard
Initial
Final
3 days
7 days
28 days
5 mins
280 - 320
15
6-00
7-30
0
4,184
4,978
5,812
Technical Data
Form
Powder
Naturals
Light Grey
Storage
Store in dry place
Shelf Life
15 months when unopened
Packaging
25 Kg / Bag
Consumption
Bonding Agent: 5 to 7 m² per liter depending on surface texture and porosity.
Ecofloor Mortar: 25 kg bag = 0.013 cubic meter